Amprobe, Attention – Amprobe Multitest-2000 Continuity-Tester User Manual
Page 37
Advertising
AMPROBE
MULTITEST2000
ν
ATTENTION:
Never disconnect the test leads from the circuit under test when
the message "MEASURING" is being displayed, as the circuit
under test may remain charged at a dangerous voltage. The
instrument has an internal "safety resistor" which is connect to
output terminal before the end of the test in order to discharge
the parasite capacities of the installation.
7. Press the START key.
The instrument will start the test.
MAN Mode: The test will take 4 seconds (maximum). If you keep
the START key pressed longer than 4 seconds the test
continues until the key is released.
TMR mode: The test will take the time set. If you want to stop
the test when it's running, press the START/STOP key again.
START
STOP
Advertising