ProSoft Technology MVI56E-MCMR - Manual (Page 45)

MVI56E-MCMR ♦ ControlLogix Platform Start Here
Modbus Communication Module with Reduced Data Block User Manual
ProSoft Technology, Inc. Page 45 of 225
May 13, 2014
3 Click to select the driver, and then click C ONFIGURE . This action opens the
Configure RS-232 DF1 Devices dialog box.
4 Click the A UTO -C ONFIGURE button. RSLinx will attempt to configure your
serial port to work with the selected driver.
5 When you see the message Auto Configuration Successful, click the OK
button to dismiss the dialog box.
Note: If the auto-configuration procedure fails, verify that the cables are connected correctly
between the processor and the serial port on your computer, and then try again. If you are still
unable to auto-configure the port, refer to your RSLinx documentation for further troubleshooting
steps.