ProSoft Technology MVI56E-MCMR - Manual (Page 80)

Configuring the MVI56E-MCMR Module MVI56E-MCMR ♦ ControlLogix Platform
User Manual Modbus Communication Module with Reduced Data Block
Page 80 of 225 ProSoft Technology, Inc.
May 13, 2014
2 The length of this COP statement must now be 14. This will COP as many of
the MCM_F LOAT _D ATA values required to occupy the
MCMR.DATA.W RITE D ATA array for a length of 14. This will take 7 registers,
MCM_F LOAT _D ATA [0] TO [6], and place that data into
MCMR.DATA.W RITE D ATA [0] TO [13].
The following illustration shows the command required to write these 7 Floating-
Point values.
Based on the Internal Address and the configuration within the B ACKPLANE
C ONFIGURATION section for Write Register Start and Write Register Count, the
data from the tag MCMR.DATA.W RITE D ATA [0] TO [6] will be written to Modbus
addresses 47001 to 47007 of Modbus Slave Device Address 1.
Note: A swap code may be required to put the data in the proper format for the slave device.