Panasonic AG-CX350 4K Camcorder - Manual (Page 42)

– 42 –
Chapter 3 Preparation — Preparing the memory card
Preventing unintentional erasing
Writing, erasing and formatting data is prohibited by setting the write-protection switch of the memory card to the LOCK side.
Write-protection switch
Status of the card access lamp and memory card
Card access lamp Memory card status
Orange (illuminated) Recording target Both loading/writing are permitted. Current recording target.
Green (illuminated) Recording possible Both loading/writing are permitted.
Orange (flashing) Accessing card Loading/writing are currently being performed.
Orange (rapidly flashing) Recognizing memory card The memory card is being recognized.
Error
An error has occurred. This will flash even if the memory card is not
inserted when an error has occurred.
Green (slowly flashing) No remaining recording capacity No recording capacity left on the memory card. Only loading is possible.
Write-protected The write-protection switch of the memory card is set to the LOCK side.
Recording not possible
It cannot record with the recording format that is currently set. Change
the recording format or use a memory card compatible with the recording
format to record.
Off No memory card inserted A memory card has not been inserted.
Illegal format It is not the correct format. Reformat the card.
Card not supported
This is a card that cannot be used with the camera, such as MMC (Multi
Media Card).
Setting to [NETWORK] menu →
[NETWORK FUNC] → [NDI | HX]
Cannot record and play back. The functions other than recording and
playback (loading of the scene file, etc.) can be used.
microP2 card formatted with
encryption with CPS password
Cannot be used with the camera. When formatted with the camera, it can
be used as a microP2 card that is not encrypted.
During card reader mode
The card 1 access lamp/card 2 access lamp turns off when not
accessing.
@ @ NOTE
t The card access lamp will not illuminate or flash when the [OTHERS] menu → [LED] → [ACCESS LED] → [OFF] is set.
Inserting/removing the memory card
Inserting the memory card
The memory card to use with the camera should always be formatted on the camera. (page 43)
f Formatting the memory card will erase all of the recorded data which cannot be restored.
Card slot cover
Card slot 1 Card 1 access lamp
Card slot 2 Card 2 access lamp
1
Open the card slot cover.
2
Insert the memory card into the card slot.
f Card slot 1 and card slot 2 can each insert one memory card.