Panasonic AG-CX350 4K Camcorder - Manual (Page 68)

– 68 –
Chapter 4 Operation — Menu settings
[Y GET] Assigns the brightness display function.
[FOCUS/IRIS] Assigns the simultaneous operation of the [FOCUS] and [IRIS].
[FOCUS/Y GET] Assigns the simultaneous operation of the [FOCUS] and [Y GET].
(Factory setting: [INHIBIT])
[IR REC]
Enables/disables the IR recording.
The items that can be set are as follows.
f [ON], [OFF]
(Factory setting: [OFF])
[AUTO SW]
[A.IRIS]
Enables/disables the auto iris control.
[ON] Performs the auto iris control operation when in auto mode. The <IRIS> button does not work.
[OFF] Does not perform the auto iris control operation when in auto mode.
This activates the iris control selected with the <IRIS> button.
(Factory setting: [ON])
[AGC]
Sets the auto gain control operations when [ON] is selected in [A.IRIS].
[ON] Performs the operation of the [AGC] function that automatically adjusts camera gain when in auto mode.
[OFF] Does not perform the operation of the [AGC] function that automatically adjusts camera gain when in auto mode.
(Factory setting: [ON])
[AGC LIMIT]
Sets the maximum gain value during [AGC] operation.
The items that can be set are as follows.
f [3dB], [6dB], [12dB], [18dB]
(Factory setting: [6dB])
[AGC POINT]
Sets the F value to switch control from auto iris to [AGC] during [AGC] operation.
The items that can be set are as follows.
f [F4.0], [F5.6]
(Factory setting: [F4.0])
[A.SHUTTER]
Sets the auto shutter control operations when [ON] is selected in [A.IRIS].
[ON] Performs the operation of the auto shutter when in auto mode.
[OFF] Does not perform the operation of the auto shutter when in auto mode.
(Factory setting: [ON])
[A.SHUTTER LIMIT]
Sets the maximum shutter value during [A.SHUTTER] operation.
The items that can be set are as follows.
f [1/100], [1/120], [1/250]
(Factory setting: [1/250])
[A.SHUTTER POINT]
Sets the F value to switch control from auto iris to [A.SHUTTER] during [A.SHUTTER] operation.
The items that can be set are as follows.
f [F8.0], [F9.6]
(Factory setting: [F8.0])
[ATW]
Sets the operations of the auto tracking white balance function.
[ON] Activates the auto tracking white balance function when in auto mode. The [ATW] function cannot be switched between
enabled and disabled with the <WHITE BAL> switch or the USER buttons.
However, if [ATW LOCK] is assigned to the USER button, the white balance value can be fixed with the USER button.
[OFF] Does not perform the [ATW] function operation in auto mode. Performs the operation of the white balance function selected
with the <WHITE BAL> switch.
(Factory setting: [ON])