HP INTEGRITY RX3600 - Manual (Page 115)

NOTE: The utility does not allow you to flash the firmware if the installed version is the
same or higher than the version on the Smart Setup media.
10. Use the tab key to scroll down into the Device section and highlight the device name.
11. Press Enter to select the device (this puts an “X” inside the box on the left side of the device
name).
12. Use the tab key to move to the OK selection and press Enter.
The firmware update begins and proceeds automatically to completion.
Configuring the Array
HP provides two utilities for manually configuring an array on a Smart Array controller:
•
ORCA , a simple ROM-based configuration utility.
• Array Configuration Utility (ACU), a versatile, browser-based utility that provides maximum
control over configuration parameters
NOTE: To copy a particular array configuration to several other servers on the same network,
use the Array Configuration Replicator (ACR) or the scripting capability of ACU. ACR is provided
in the SmartStart Scripting Toolkit, available on the HP Web site at:
http://www.hp.com/servers/sstoolkit .
Whichever utility you use, the following limitations apply:
•
For the most efficient use of drive space, do not mix drives of different capacities within the
same array. The configuration utility treats all physical drives in an array as if they have the
same capacity as the smallest drive in the array. The excess capacity of any larger drives is
wasted because it is unavailable for data storage.
• The probability that an array will experience a drive failure increases with the number of
physical drives in the array. If you configure a logical drive with RAID 5, keep the probability
of failure low by using no more than 14 physical drives in the array.
For conceptual information about arrays, logical drives, and fault-tolerance methods, and for
information about default array configuration settings, see the HP Array Configuration Utility
User Guide at I/O Cards and Networking Software at:
http://docs.hp.com/en/netcom.html
Comparing the Utilities
Table 3-17 lists the supported features and procedures for the ACU and ORCA utilities.
Table 3-17 ACU and ORCA Supported Features and Procedures
ORCA ACU
Supported Features
No Yes Uses a graphical interface
No Yes Available in languages other than English
No Yes Available on CD
No Yes Uses a wizard to suggest the optimum configuration for an unconfigured controller
No Yes Describes configuration errors
No Yes Suitable for configuration while online
Yes No Suitable for configuration while offline
Core I/O Card Configuration 115