HP INTEGRITY RX3600 - Manual (Page 302)

Syntax
cfggen <controller #> delete [noprompt]
Parameters
<controller #> A SAS controller number between 0 and 255.
[noprompt] Eliminates warnings and prompts.
Operation
After entering the DELETE command, the system prompts you and asks if you want to proceed
with the command. Enter Yes if you want to proceed.
DISPLAY
This DISPLAY command displays information about controller configurations: controller type,
firmware version, BIOS version, volume information, and physical drive information.
Syntax
cfggen <controller #> display [filename]
Parameters
<controller #> A SAS controller number between 0 and 255.
[filename] Valid filename to store output of command to a file.
Sample Output
Read configuration has been initiated for controller 0
------------------------------------------------------------------------
Controller information
------------------------------------------------------------------------
Controller type : SAS1068
EFI BSD version : 2.00.09.00
Firmware version : 1.10.01.00
Channel description : 1 Serial Attached SCSI
Initiator ID : 63
Maximum physical devices : 62
Concurrent commands supported : 511
------------------------------------------------------------------------
IR Volume information
------------------------------------------------------------------------
IR volume 1
Volume ID : 2
Status of volume : Okay (OKY)
RAID level : 1
Size (in MB) : 34304
Physical hard disks (Target ID) : 9 1
------------------------------------------------------------------------
Physical device information
------------------------------------------------------------------------
Initiator at ID #63
Target on ID #1
Device is a Hard disk
Enclosure # : 1
Slot # : 8
Target ID : 1
State : Online (ONL)
Size (in MB)/(in sectors) : 34732/71132960
Manufacturer : HP
Model Number : DG036A8B53
Firmware Revision : HPD6
Serial No : 3LC04757000085425VFK
Drive Type : SAS
Target on ID #4
302 Core I/O Card Utilities