HP INTEGRITY RX3600 - Manual (Page 239)

Figure 6-29 Battery Location on the Core I/O Board
Core I/O
Board
Battery
Replacing the Core I/O Board Battery
To replace the core I/O board battery, follow these steps:
1. Insert the replacement battery into the socket.
NOTE: The positive terminal of the battery is designated by a + sign. Install the battery
with the + sign facing up.
2. Replace the core I/O board. See “Replacing the Core I/O Board” (page 237) .
3. Replace the top cover. See “Replacing the Top Cover” (page 182) .
4. If rack installed, slide the server completely into the rack. See “Inserting the Server into the
Rack” (page 180) .
5. Reconnect the power cables and power on the server. See “Powering On the Server”
(page 94) .
6. Restore the iLO 2 MP configuration settings using the server console. For additional
information about using the iLO 2 MP see the HP Integrity Integrated Lights-Out 2 Management
Processor Operations Guide.
Removing and Replacing the SAS Core I/O Card
The SAS core I/O card connects to the SAS disk backplane and controls internal data storage
operations for the server. There are four types of SAS core I/O cards supported on the server:
• Half length generic SAS card (PCI-X)
• Full length SAS card with RAID capability (PCI-X or PCIe)
• Full length SAS card with RAID capability able to connect to external storage (PCIe)
Removing and Replacing the SAS Core I/O Card 239