HP INTEGRITY RX3600 - Manual (Page 187)

Figure 6-6 Removing and Replacing a Hot-Swappable Power Supply
P0
P1
Rear Chassis View
Replacing a Hot-Swappable Power Supply
To replace a hot-swappable power supply, follow these steps:
1. Remove the metal filler panel.
2. Support the new power supply with both hands, and slide it into the empty slot until it
clicks into place (
Figure 6-6 ).
IMPORTANT: Ensure the power supply is flush with the adjacent power supply or metal
filler panel.
3. Plug the power cord into the power supply receptacle.
NOTE: The LED immediately turns on when power is applied.
4. Replace the cable management arm.
Removing and Replacing a Hot-Swappable Power Supply 187