HP INTEGRITY RX3600 - Manual (Page 80)

Applying Standby Power to the Server
To apply standby power to the server, follow these steps:
IMPORTANT: If the server has one BPS, plug the power cable into the receptacle labeled PWR
1.
1. Locate the appropriate receptacle on the rear of the chassis. Plug the power cord into the
receptacle.
2. Observe the following LEDs at two different intervals to ensure the server is in the standby
power state:
INTERVAL ONE After you plug the power cord into the server, the BPS flashes green and
an no light is present on the hard disk drives.
INTERVAL TWO Approximately 30 seconds later, the BPS is green and no light is present
on the hard disk drives. Standby power is now on.
LAN
The server has two LAN ports that can provide network connectivity.
Figure 3-16 shows the available LAN ports for the server.
Figure 3-16 Rear Panel LAN Ports
To enable general network connectivity for the server, follow these steps:
1. Obtain valid IP addresses for each LAN port you plan to activate.
2. Connect the LAN cable from an available LAN port to a live connection on the network.
Console Setup
Setting up the console involves the following:
1.
Determining the physical access method to connect cables. There are two physical connections
to the Integrity iLO 2 MP:
•
RS-232 serial port
• iLO 2 MP LAN port
2. Configuring the Integrity iLO 2 MP and assigning an IP address if necessary. Though there
are several methods to configuring the LAN, DHCP with DNS is the preferred one. DHCP
with DNS comes preconfigured with default factory settings, including a default user account
and password. Other options include:
•
ARP-Ping
• RS-232 serial port
80 Installing the System