HP INTEGRITY RX3600 - Manual (Page 94)

Table 3-14 Power States
DC Voltage
Applied AC Voltage
Applied Powered On With the iLO 2 MP PC
Command; or Front Panel Power Button
Pressed Power Cable
Plugged into
Receptacle Power States
No Yes No Yes Standby power
Yes Yes Yes Yes Full power
No No No No Off
NOTE: If the power restore feature is set to Always On through the iLO 2 MP PR command,
the server can automatically power on to the full power state.
Powering On the Server
Power on the server to full power using the following methods:
•
iLO 2 MP PC command
• Power button
Powering On the Server Using the iLO 2 MP
NOTE: If the power restore feature is set to Always On through the iLO 2 MP PR command,
the server can automatically power on to the full power state.
To power on the server using the iLO 2 MP, follow these steps:
1. Plug all power cables into the receptacles on the rear panel of the server.
2. Initiate a console session and access the MP Main Menu.
3. Enter CM to enable command mode.
4. Enter PC to use the remote power control command.
5. Enter ON to power on the server, and enter YES when prompted to confirm the action.
6. Start the operating system. For more information see the operating system documentation.
Powering On the Server Manually
NOTE: If the power restore feature is set to Always On through the iLO 2 MP PR command,
the server may automatically power on to the full power state.
To manually power on the server, follow these steps:
1. Plug all power cables into the receptacles on the rear panel of the server.
2. Press the power button to start the server.
94 Installing the System