HP INTEGRITY RX3600 - Manual (Page 355)

support, 28
PCIe MPS optimize
ioconfig command, 326
pedestal, converting from rack mount, 78
pedestal-mount server
accessing, 180
ports
front panel locations, 36
rear panel locations, 41
power, 32
(see also power supply)
block diagram, 33
button, 118
full state, defined, 93
input, 81
introduction, 32
off state, defined, 93
PR command, 94
problems, 118
sources, 79
standby state, defined, 93
states, 79, 93
power button
function, 37
LED, 37
power reset command (see PR)
power subsystem (see power)
power supplies
installing hot-swappable, 58
loading guidelines, 59
power supply
LEDs, 44
load order, 186
removing, 186
replacing, 187
power supply, hot-swappable
replace, 59
powering off the server, 95
manually, 95
using the iLO 2 MP PC command, 95
powering on the server, 94–95
manually, 94
using the iLO 2 MP PC command, 94
PR command, 94
Pre-OS System Startup Environment (POSSE), 35
processor
configuration options, 75, 218
installing, 75, 223
introduction, 29
load order, 75, 219
removing, 219
required service tools, 75, 219
restrictions, 75, 219, 280
upgrading, 279–281
Processor Abstraction Layer (see PAL)
processor board (see processor board assembly)
processor board assembly
removing, 217
replacing, 218
processor board assembly, removing and replacing, 73
R
rack
anti-tip features, 180
extending the server from, 180
extension clearance, 180
inserting the server into, 180
screw locations, 180
slide kit, 179
rack, installing server, 78
rack-mount server
accessing, 179
rackless (see pedestal-mount)
rear panel
control, port, and LEDs locations, 41
functional overview, 40
remove and replace
DIMMs, 67
disk drive, hot-pluggable, 60
extender board, memory, 65
memory extender board, 65
PCI/PCI-X/PCIe cards, 62
reset button
iLO 2 MP, 42
returning damaged equipment, 55
RS-232 serial port, using to configure iLO 2 MP, 88
S
safety information, 262
safety information, general, 53, 178
SAS
features and capabilities, 246
technology overview, 246
SAS backplane board
removing, 247
replacing, 249
sas controller, 96
SAS core I/O card
removing, 240
replacing, 240
slot restrictions, 240
supported card types, 239
saupdate utility, 110
SCSI
setup utility, 337
specifying parameters, 337
SCSI adapter
path, 338
security
access settings, 90
optional component, TPM, 120
risk with DHCP enabled, 90
setting up, 90
serial-attached SCSI (see SAS)
service tools, 177
smart array P400 controller, 109, 306
smart array P600 controller, 109, 306
smart array P800 controller, 109, 306
355