HP INTEGRITY RX3600 - Manual (Page 308)

IMPORTANT: Both saupdate.efi and the firmware image file must be located in the same
directory. If they are not, copy them both to the EFI partition. Run the saupdate.efi using the
fs0:\> saupdate
command.
• If you are not using the Offline Diagnostic CD:
1. Download the SA EFI update utility saupdate.efi and copy it to the EFI partition.
2. Download the firmware and copy it to the EFI partition.
3. Boot the system to the EFI Shell and change directories to the EFI partition.
4. Run the saupdate.efi using the using the fs0:\> saupdate.efi command. The
following screen displays. The version of the utility displays on the second line:
*************************************************************
Smart Array Offline Firmware Update Utility
Version: 1.04.12.00
(C) Copyright 2004 Hewlett Packard Development Company L.P.
*************************************************************
Syntax
saupdate <operation> <parameters>
Commands
You can use the following operations with saupdate:
•
LIST
• UPDATE
• UPDATE all
• HELP or?
List
Use LIST to display all detected Smart Array controllers along with the active firmware versions.
fs0:\> saupdate LIST
*************************************************************
Smart Array Offline Firmware Update Utility
Version: 1.04.12.00
(C) Copyright 2004 Hewlett Packard Development Company L.P.
*************************************************************
Seg Bus Dev Func Description Version
1 51 4 0 HP Smart Array 6400 1.92
1 20 1 0 HP Smart Array 5300 3.54
The identification information from this list is used to designate which controller is to be updated.
UPDATE
NOTE: The saupdate utility program file (saupdate.efi) must be located in the same file
system as the firmware files.
saupdate UPDATE [ <seg:bus:dev:func>] [smartarray_firmware_file]
For example, to update the controller at segment 1, bus 51, device 4, function 0 from the example
output above, enter a command at the EFI Shell prompt as in this following example:
fs0:\> saupdate UPDATE 1:51:4:0 CYBORG234.BIN
Replace CYBORG234.BIN with the name of your firmware file.
The following screen displays:
*************************************************************
Smart Array Offline Firmware Update Utility
308 Core I/O Card Utilities