Installing and removing the air flow guide, Removing the air flow guide – Intel SR9000MK4U User Manual
Page 117
Intel
®
Server System SR9000MK4U Product Guide
95
Installing and Removing the Air Flow Guide
Before beginning these steps, power down your server system and unplug all AC power
cords.
You will need to remove the airflow guide to complete the following procedures:
•
To install or remove the fan box
•
To install or remove the hard drive backplane cover
•
To install or remove the hard drive backplane
•
To install or remove the mounting plate
•
To install or remove a processor
Removing the Air Flow Guide
To perform this procedure, you will first need to remove:
•
The top cover. For instructions, see
“Removing the Top Cover” on page 36
•
All installed power supplies. For instructions, see
.
•
The power supply filler panel, if one is installed. For instructions, see
•
The power supply box. For instructions, see
“Removing the Power Supply Box” on
.
•
The KVM card, if it is installed. For instructions, see
.
•
All installed PCI cards. For instructions, see
“Removing a PCI Card” on page 63
•
The PCI card divider. For instructions, see
“Removing the PCI Card Divider” on
.
Remove these components, in order, before beginning the steps below.
The steps below do not guide you through reinstalling the components you are removing
or disconnecting in this step sequence. These steps assume you are removing the air flow
guide to either replace it, or to access another component. After completing these steps,
continue with the steps that directed you to this section, or follow the steps under
“Installing the Air Flow Guide” on page 97
to replace your air flow guide.