Intel SR9000MK4U - Manual (Page 55)

33
3
Installing and Removing
Components
To complete many of the installation or removal procedures in this chapter, you will need
to first install or remove other components. For example, to remove the PCI card divider,
you first need to remove the chassis cover, the power supplies, the power supply box, the
CPU1/CPU2 MVR cable, the KVM card, and all add-in cards. This guide will direct you
to each installation / removal section as is necessary to accomplish your final goal. This
means you may need to change pages several times to move from one procedure to the
next.
Cautions:
• Installing and replacing optional components inside the server is to be performed
only by trained personnel.
• Before following any of the procedures in this chapter, review all of the safety
instructions located in
“Safety Information” on page 193 .
• Unless you are performing a hot swap function for hot swap instructions are
provided, you must turn off your system and disconnect all power plugs before
beginning any procedure in this chapter.
• Do not subject the hard drive to vibrations or impacts. Drive failure may result from
vibrations or impacts.
• Before hot-swapping, be sure to completely understand the procedures written in
this manual.
Tools Needed
The following tools are needed to install or remove the hardware described in this chapter.
• Phillips* screwdriver #2
• Flathead screwdriver 5.5 x 75
• 2.5 mm hex driver
• Torx-15* driver
• Cotton gloves
• Antistatic wrist strap