Intel SR9000MK4U - Manual (Page 96)

74 Intel ® Server System SR9000MK4U Product Guide
3. Disconnect the power cable from the power supply you want to replace.
4. Remove the power supply. For instructions, see “Removing a Power Supply” on
page 70 . Return to these steps after removing the power supply.
5. Install the new power supply. For instructions, see “Installing a Power Supply” on
page 68 .
6. Install the top cover. For instructions, see “Installing the Top Cover” on page 37 .
Installing and Removing the Front Control Panel
and Optical Drive Assembly
Removing the Front Control Panel and Optical Drive
Assembly
Before beginning these steps, power down your server system and unplug all AC power
cords.
To perform this procedure, you will first need to remove the front bezel. The steps below
will direct you to the instructions to remove the front bezel at the appropriate location in
the step sequence.
1. Remove the front bezel. For instructions, see “Removing the Front Bezel” on
page 34 .
2. Push and hold the levers on each sides of the front control panel / DVD-ROM drive
assembly. See letter “A” in the figure below.
3. Pull out the front control panel / optical drive assembly. See letter “B” in the figure.
Figure 71. Removing the Front Control Panel and Optical Drive Assembly
AF001211
A
B