Intel SR9000MK4U - Manual (Page 73)

Intel ® Server System SR9000MK4U Product Guide 51
Installing and Removing an Optical Drive
Installing an Optical Drive
To perform this procedure, you will first need to remove the front bezel. The steps below
will direct you to the instructions on removing the front bezel at the appropriate location
in the step sequence.
Note: Before performing the procedures in this section, turn off the system and disconnect all
power plugs.
1. Remove the front bezel. For instructions, see “Removing the Front Bezel” on
page 34 .
2. Locate the optical drive location at the left side of the system. See the following
figure.
Figure 38. Locating the Optical Drive Installation Position
3. Push the lever on the side of the optical drive or the filler panel to remove it from
the system. Keep the filler panel for future use.
Figure 39. Removing the Optical Drive Filler Panel
AF001129
A