Intel SR9000MK4U - Manual (Page 92)

70 Intel ® Server System SR9000MK4U Product Guide
5. Push down the two levers on the top of the power supply to lock it into place. See
letter “A” in the figure below.
6. Lower the handle on the power supply. See letter “B” in the figure.
Figure 66. Locking the Power Supply into Place
7. Determine your next course of action and refer to the appropriate steps:
— If you are following these steps as part of another procedure, return to that
procedure.
— If you are done working inside your server system, install the top cover. For
instructions, see
“Installing the Top Cover” on page 37 .
Removing a Power Supply
To perform this procedure, you will first need to remove the top cover. The steps below
will direct you to the instructions to remove the top cover at the appropriate location in the
step sequence.
Cautions:
• Before performing the procedures in this section, except for when hot-swapping,
turn off the system and then disconnect all power plugs.
• Care must be taken when you replace the power supply module; the cover or handle
is hot when the system is powered on.
• Before removing the power supply, pull up two levers to release the connector
between power supply and main board.
AF001153
A
A
B