Intel SR9000MK4U - Manual (Page 144)

122 Intel ® Server System SR9000MK4U Product Guide
Disassembling a Processor Assembly
Before beginning this procedure, follow all steps necessary to remove the processor from
the server system. For instructions, see
“Removing a Processor” on page 111 .
1. On the underside of the MVR, install the protective cover over on the LGA
terminal.
Figure 122. Installing the LGA Terminal Cover
2. Use a Torx-15 screwdriver to loosen the four screws on the corners of the heat sink.
See letter “A” in the figure below.
3. Use a hexagonal wrench to turn the processor lock counter-clockwise to unlock the
processor socket. See letter “B” in the figure.
4. Verify that the processor lock is in the unlocked position. See letter “C”.
5. Lift the processor and heat sink assembly straight up to remove it from the server.
Figure 123. Loosening the Heat Sink Screws
AF001254
AF001255
A A
B
A
A
C