Intel SR9000MK4U - Manual (Page 60)

38 Intel ® Server System SR9000MK4U Product Guide
Installing a Hard Drive
Caution: Before performing the procedures written in this chapter, except for when hot-swapping,
be sure to turn off the system and disconnect all power plugs.
1. Push down on the button at the top of the drive carrier lever. See letter “A” in the
figure below.
2. While holding down the button, pull forward on the lever to open it. See letter “B”.
3. Continue pulling on the lever to slide the carrier from the system.
Figure 25. Pulling Down on the Hard Drive Carrier Lever
4. Remove the four screws at the sides of the hard drive carrier. Two screws are at
each side of the carrier. See letter “A” in the figure below.
Note: Do not remove the metal EMI shield from the carrier.
5. Set the hard drive into the hard drive carrier, with the connections extending from
the rear of the carrier.
6. Install the four screws that you removed in step 4, two on each side of the carrier.
See letter “A” in the figure below.
AF001108
A B