Removing a processor – Intel SR9000MK4U User Manual
Page 133
Intel
®
Server System SR9000MK4U Product Guide
111
Removing a Processor
To perform this procedure, you first need to remove:
•
The top cover. For instructions, see
“Removing the Top Cover” on page 36
•
All installed power supplies. For instructions, see
.
•
The power supply filler panel, if one is installed. For instructions, see
•
The power supply box. For instructions, see
“Removing the Power Supply Box” on
.
•
Remove the hard drive backplane cover. For instructions, see
Drive Backplane Cover” on page 87
.
•
The KVM card, if it is installed. For instructions, see
.
•
All installed PCI cards. For instructions, see
“Removing a PCI Card” on page 63
•
The PCI card divider. For instructions, see
“Removing the PCI Card Divider” on
.
•
The air flow guide. For instructions, see
“Removing the Air Flow Guide” on
.
Remove these components, in order, before beginning the steps below.
The steps below do not guide you through reinstalling the components you are removing
or disconnecting in this step sequence. These steps assume you are removing the
processor to either replace it, or to access another component. After completing these
steps, continue with the steps that directed you to this section, or follow the steps under
“Installing the Processor” on page 113
to replace your processor.