Muratec MX-2030 - Manual (Page 252)

7-20 C
OPYING
6
(1) Press [Bind] to set the document bind position.
• Press [DuplexCopy]* to return to the duplex copy display.
* Not displayed if the duplex printing unit is not installed.
(2) Press [Right&Left] or [Top].
(3) Press [Enter].
7
Press [Enter] twice to return to the standby display.
Press [Reset] to cancel the duplex copy settings.
8
Press [Start].
The front side of the duplex document will be scanned.
9
When the following display is shown, place the backside of the duplex docu-
ment in the same direction as the front side and press [Start].
• Press [Stop] to cancel.
• Be sure to set the document in the correct direction. (See the table on page
7-16.)