Muratec MX-2030 - Manual (Page 338)

12-6 M
ACHINE
S
ETTINGS
The underlined settings are the factory defaults.
Function Description Setting
Redial Attempts This sets the number of times for redial attempts when the destination line is busy. The
interval between redial attempts is set at “Redial Interval”.
2–15 times: 2
times
Redial Interval This sets the interval between redial attempts. 1–5 minutes: 1
minute
Block Junk Fax
(See page 3-46.)
This function enables you to block receipt of unnecessary faxes.
Number of
Rings
This sets the number of times the machine will ring before fax reception when the recep-
tion mode is set to Fax or Tel/Fax.
1–10 times: 2
times
Dialing Pause This sets the default for the dialing interval (2-10 seconds) when the pause symbol is
input.
2–10 seconds: 2
seconds
Super-Fine
Resolution
This sets the dpi for resolution when a document is scanned for S-Fine transmission. If
600 dpi is set, the scan is sharper than with 400 dpi; however, it may result in memory
overflow when the document is sent.
600dpi
400dpi
Rx Reduction
Rate
(See page 3-20.)
Select from [Auto], which automatically selects the magnification according to the length
of the received document, or [100%] to have all faxes printed out at the same rate of
reduction.
Auto
100%
Reduction
Margin
(See page 3-20.)
This sets at what point the document printout will extend to the following page if the
received document cannot fit within the effective recordable area.
0.0–3.3 inches:
1.5 inches
Paper Saving
(See page 3-21.)
This sets the print method for the received documents.
If it is set to “H-Page Rx” and 2 pages of Half-Letter is received in succession, the two
pages will be reduced at the appropriate rate and printed out on one sheet of paper.
If it is set to “Duplex Rx*”, both sides of each sheet of paper will be used for printouts.
*A duplex printing unit is required for duplex reception.
OFF
H-Page Rx
Duplex Rx*
Quick Memory
Tx
If this is set to [ON], fax transmission for multiple documents will begin in the page order
when it has been scanned and stored.
ON
OFF
ECM Mode Any part of a fax that was not send correctly due to the line error will automatically be
resent. (The destination must have the same function for it to work.)
ON
OFF
Service Mode Do not set. –
Dial PreFix
(See page 3-44.)
The connection number as Dial PreFix No. can be registered to allow easy access to other
phone networks.
Receive Time
Stamp
If this is set to [ON], the received date (year, month, day) and time can be printed with
the word “Received” at the header of the received document.
MAY 5 2005 02:16pm
MAY 5 2005 02:15pm P.01/01
NOTE: If the receiving reduction rate is fixed to 100% and the reduction margin setting
is small, the received document could be divided into 2 sheets by attaching the
Receive Time Stamp.
OFF
ON