Muratec MX-2030 - Manual (Page 378)

14-22 M
AINTENANCE
& T
ROUBLESHOOTING
Message on the display Description / Solution
The number of the
browse results exceeds
the limit.
You browsed a folder where too many files or folders are located. To scan to the folder,
register the folder as a shortcut using the [Keypad] or select another folder. To attach
files from the folder, copy the files to a new folder and attach them.
The numeric keypad
cannot be used.
You cannot use numeric keys while selecting group members.
The storing process has
not finished.
The machine cannot execute the job until the current job finishes. Please wait.
The toner is empty. Toner is empty. Replace with a new toner bottle.
The toner is low. Your machine is almost out of toner.
Please contact your Muretec dealer soon to purchase a new toner cartridge.
The value entered
exceeds the limit. Please
enter a value within the
listed range.
You entered a value or number that exceeds the range. Confirm the range on the display
and enter it again.
There are no vacant
numbers.
You have already registered 300 locations to the Address Book. To register a new loca-
tion, first delete the unnecessary locations first.
There is no applicable
data.
You selected a key on the index, to which no destination is categorized.
This function cannot be
used.
You selected a function that is currently not available. Change the function you set prior
to this function or cancel this function.
This Resolution cannot
fit specified Zoom value.
You try to set a resolution that is not available in the set zoom ratio. Change either the
resolution or the zoom ratio to do the job.
This setting is protected The department management setting is protected. To change the setting, release the
protection.
To initialize IP address
you must shutdown.
IP address is entered or edited. Power off and then on to save the setting.
Toner should be
replaced.
Toner is empty. Replace with a new toner bottle.
Too many characters You entered more characters than the limit. Re-enter them so that it contains the limit.
Too many locations. You entered more location than the limit. Re-enter them so that it contains the limit.
TTI data has not been
registered
The Transmit Terminal Identifier (TTI) is not registered. To select the TTI, register the
TTI in advance.
Unable to delete. The job you selected was carried out before deleting.
Use the scanner glass You tried to make a zoom up copy using the ADF. To make a zoom up copy, use
the document glass.