Muratec MX-2030 - Manual (Page 85)

3-3 F
AXING
1
2
3
5
6
7
8
9
10
11
4
F
AXING
13
AI
12
Scanning contrast
Setting the scanning contrast allows you to compensate for any excessive lightness
or darkness, as the case may be, of the document pages you are sending.
To change the scanning contrast:
1
Press [FAX] to display the Fax standby mode.
2
Press [Contrast].
3
Select one of the contrast types.
Lighest
Darker Lighter
Normal
Darkest
4
Press [Enter].
NOTE: You can change the default setting for [Contrast]. See “Accessing the default
settings” on page 12-4.
Sending method
The following four sending methods are available on your machine.
Memory transmission:
For a normal memory transmission, your machine: (1) scans the entire document
into memory, (2) dials the other fax machine, and (3) transmits the document.
Quick memory transmission:
For a quick memory transmission, your machine doesn’t wait to scan all pages into
memory before dialing. After it scans the first page of your document, your machine
will dial the other fax machine. When it makes contact, your machine transmits
the stored document from memory while at the same time scanning the remaining
pages of your document into memory.
The quick memory transmission is defaulted to [ON]. However, you can turn the
defaut to [OFF]. (See “Fax settings” on page 12-4.)