Muratec MX-2030 - Manual (Page 91)

3-9 F
AXING
1
2
3
5
6
7
8
9
10
11
4
F
AXING
13
AI
12
Manual transmission (non-memory transmission)
1
Set the document.
2
Press [FAX] to display the Fax standby mode.
3
Press “Fax” tab.
4
Adjust the scanning resolution and contrast, if necessary. (See page 3-2.)
5
Press [Monitor].
– or –
Lift the handset if you have connected an optional handset or an external tele-
phone to your machine.
In either case, the following display will appear:
6
Specify the destination.
• Use the numeric keys to dial the number.
– or –
• Specify the destination using the address book. (See page 2-12.)
Press [Monitor] on hang up the handset to cancel the settings.
NOTE: You can dial only one destination for manual transmission.
7
When you hear fax tones from the remote fax machine, press [Start].
If a person answers the phone, use the handset to tell that person that you are
trying to send a fax. When you hear fax tones, press [Start].
If the call fails when you use [Monitor] to dial, press [Monitor] to hang up.
If you are using the handset, hang up after pressing [Start].
• To cancel the transmission, use the Review Commands feature. (See “Chapter
6 Reviewing or canceling commands”)