GE Industrial Solutions Entellisys 4.0 System User Manual - Manual (Page 144)

Sequence of events, fault reports and waveform capture records 144
9
9.2.3 Configuring the waveform viewer
Click the Config button to display the waveform viewer setup window, as shown in Figure 9-9.
Figure 9-9 Waveform viewer setup window
This window enables the selection of channels to be plotted in various colors, line styles, and
groups for simultaneous display. These channels can be a combination of Analog and Digital
channels.
Click the Digital tab, as shown in Figure 9-10. When a change of state is detected within the
record, a check mark appears beside the corresponding operand in the Change Detected
column.
Figure 9-10 Digital Channel Setup tab