IDEC High Performance Series - Manual (Page 116)

Chapter 2
98
External Device Setup Manual
2. PLC Settings
Refer to the Q Corresponding Ethernet Interface Module User’s Manual or Q Corresponding Ethernet Interface Module
User’s Manual for detail.
Item setting notes
Network parameter Network type Ethernet *1
*1. The setting of the above-mentioned is recommended.
Starting I/O No. 0020 *2
*2. Set it according to the environment.
Network No. 1 *2
Total stations - -
Group No. 0 *2
Station No. 1 *2
Mode On line *1
Operation Setting Communication data code Binary code *1
Initial Timing Always wait for OPEN *1
IP Address Input format Decimal *2
IP address Set IP address of PLC *2
Send frame setting Ethernet *1
Enable Write at RUN time Check mark (enable) *1
TCP Existence confirmation setting Use the Keep Alive *1
Open Setting Protocol TCP/IP *1
Open system Impassive open *1
Fixed buffer Send *1
Fixed buffer communication Procedure exist *1
Pairing open No pairs *1
Existence confirmation No confirm *1
Local station Port No. Set an arbitrary port number *2 *3
*3. MICRO/I is set by the decimal number though PLC is set by the hexadecimal number.
Destination IP address - -
Dest. Port No. - -