IDEC High Performance Series - Manual (Page 308)

Chapter 2
290
External Device Setup Manual
8.3 Connection Diagram
The connector types given in the Connection Diagrams are for the unit and not the cable. For details regarding wiring, refer
to Chapter 1 "3 Important Points Regarding Wiring" on page 19.
8.3.1 Connection Diagram 1: S10mini (RS422/485) to MICRO/I
There is no pin number corresponding to TERM on the HG2G-S/-5S/-5F, HG3G/4G. When inserting a termination resistor,
use a communication switch. For the setting of the switch, refer to Chapter 1 "3 Important Points Regarding Wiring" on
page 19.
When you use the Terminal Block type of HG2G-S/-5S/-5F, HG3G/4G, make sure to configure the Hardware Flow control
to NONE.
D-sub, 9P connector plug type D-sub, 9P connector plug type
D-sub, 9P connector plug type Terminal