Refer to p176), External device setup manual – IDEC High Performance Series User Manual
Page 194
Advertising
Chapter 2
176
External Device Setup Manual
4.3.4
Connection Diagram 4: PLC-5 (RS422) to MICRO/I
There is no pin number corresponding to TERM on the HG2G-S/-5S/-5F, HG3G/4G. When inserting a termination resistor,
use a communication switch. For the setting of the switch, refer to Chapter 1 "3 Important Points Regarding Wiring" on
page 19.
D-sub, 25P connector socket type (unit side)
D-sub, 9P connector plug type
D-sub, 25P connector socket type (unit side)
Terminal
Advertising
This manual is related to the following products: