Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 121)

Removing a management module
Before removing a management module, have the following tools on hand:
• An ESD wrist strap with a plug for connection to the ESD connector on the chassis.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megohm resistor.
• A #2 Phillips-head or flathead screwdriver.
To remove a management module from the chassis, perform the following tasks.
1. Refer to the “Installation precautions.”
2. If your Brocade chassis does not have redundant management modules, power down the chassis
and remove the power cables from the chassis power supplies.
3. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector
located on the chassis front.
4. Use a #2 Phillips-head or flathead screwdriver to loosen and remove the two screws on the ends of
the module.
5. Pull the card ejectors towards you, and away from the module front panel. This action unseats the
module from the backplane.
6. Pull the module out of the chassis, and place in an anti-static bag for storage if desired.
7. Install a new module in the slot.
Installing a new management module
Before installing a module into the chassis, have the following on hand:
• A new management module, which you can order from Brocade.
• An ESD wrist strap with a plug for connection to the ESD connector on the chassis.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megohm resistor.
• A #2 Phillips-head or flathead screwdriver.
To install a new management module in the chassis, perform the following tasks.
1. Refer to the “Installation precautions” section.
2. If your Brocade chassis does not have redundant management modules, power down the chassis
and remove the power cables from the chassis power supplies.
3. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector
located on the chassis front.
4. Remove the new management module from its packaging.
5. Insert the module into the chassis slot as shown in the figures below and slide the card along the
card guide until the ejectors on either side of the module move close to the module front panel.
6. Push the ejectors toward the center of the module. This action will fully seat the module in the
backplane.
7. Use a #2 Phillips-head or flathead screwdriver to tighten the two screws at either end of the
management module’s front panel.
Removing a management module
Brocade FastIron SX Series Chassis Hardware Installation Guide 119
53-1003092-01