Brocade FastIron SX Series Chassis Hardware Installation Guide User Manual
Page 137
To remove a DC power supply, perform the following tasks.
1.
Disconnect the wires to your DC power source.
2.
Use a flat-blade screwdriver to remove the two screws holding the transparent cover over the
power supply lugs.
1
Screws holding power lugs
2
Screws holding transparent cover
FIGURE 50 DC power supply
3.
Use a Phillips-head screwdriver to remove each of the power lugs.
4.
Remove both wires from the power lugs.
5.
Release the latch on the front of the power supply to unlock the power supply from its position in
the chassis:
•
‐
Locate the 1/2 in tab (latch release) on the bottom center of the front of the power
supply
‐
Firmly press on the latch release
‐
The latch should spring open
‐
Gently push the latch to the right
Maintaining the Hardware
Brocade FastIron SX Series Chassis Hardware Installation Guide
135
53-1003092-01