Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 129)

1. Follow the preparation procedure in the section Before removing an interface module on page 125.
2. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector
located in the lower right corner of the chassis front.
3. Remove the module from its packaging.
4. Insert the module into the chassis slot as shown in the figures below, and slide the card along the
card guide until the ejectors on either side of the module move close to the module front panel.
5. Push the ejectors in toward the center of the module. This action will fully seat the module in the
backplane.
6. Use a #2 Phillips-head or flathead screwdriver to tighten the two screws at either end of the module
front panel.
NOTE
You do not need to enable an interface module after inserting it in the chassis. The FastIron X
Series chassis device automatically enables the module when you insert it into a live chassis or
when you power on the chassis.
1 Interface module
FIGURE 46 Installing an interface module in the FSX 800 chassis
Maintaining the Hardware
Brocade FastIron SX Series Chassis Hardware Installation Guide 127
53-1003092-01