Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 136)

To remove an original AC power supply, perform the following tasks.
1. Disconnect the power supply’s power cord from the wall outlet.
2. Disconnect the power cord from the chassis rear panel.
3. Release the latch on the front of the power supply to unlock the power supply from its position in
the chassis:
• ‐ Locate the 1/2 in tab (latch release) on the bottom center of the front of the power
supply.
‐ Firmly press on the latch release.
‐ The latch should spring open.
‐ Gently push the latch to the right.
4. Gently pull on the power supply latch until the power supply is removed from the chassis.
5. Install a new power supply in the slot. For information about performing this task, refer to the
“Installing a new power supply” section.
Removing a DC power supply
You can order a new DC power supply from Brocade Communication Systems, Inc.
DANGER
The power supplies are hot swappable, which means they can be removed and replaced while
the chassis is powered on and running. However, Brocade recommends that you disconnect
the power supply from the wall outlet before removing and replacing the supply. The chassis
can be running while a power supply is being removed and replaced, but the power supply
itself should not be connected to a power source. Otherwise, you could be injured or the power
supply or other parts of the device could be damaged.
Removing a DC power supply
134 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01