Installing an original power supply, Connecting ac power to the chassis – Brocade FastIron SX Series Chassis Hardware Installation Guide User Manual
Page 142
Installing an original power supply
This section describes how to install an original power supply.
The following illustration shows the original power supplies.
NOTE
For the differences between the replacement and original power supplies, refer to the “Replacement
power supplies” section.
To install an original power supply, perform the following tasks.
1.
Release the latch on the front of the new power supply to unlock it:
•
Locate the 1/2 in tab (latch release) on the bottom center of the front of the power supply
•
Firmly press on the latch release
•
The latch should spring open
•
Gently push the latch to the right
CAUTION
Do not attempt to install the power supply without first releasing the latch on the front of
the power supply. Attempting to install the power supply with a closed latch will result in
mechanical damage to the power supply and power supply slot.
2.
Insert the new power supply into the empty power supply slot.
CAUTION
Make sure the power supply is properly inserted in the slot. Never insert the power supply
upside down.
3.
When the power supply is fully seated, the power supply latch will catch onto a tab located on the
right side of the power supply slot. Once the power supply is fully seated, push firmly on the
power supply latch until it locks the power supply into place.
4.
Connect power to the chassis. Refer to the “Connecting AC power to the chassis” section or the
“Connecting DC power to the chassis” section.
Connecting AC power to the chassis
AC power is supplied though an AC power cord that is installed at the rear of the chassis.
1.
At the rear of the chassis, locate the power receptacle where the power supplies have been
installed.
2.
Lift the cord-retainer and connect a Brocade-supplied AC power cord to the power supply.
3.
Snap the cord-retainer over the power plug to hold it in place, as illustrated below.
Installing an original power supply
140
Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01