Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 63)

Slot numbers for module installation (Continued) TABLE 17
Module FSX 800 Slot Numbers FSX 1600 Slot Numbers
48-port POE+ interface modules
(SX-FI48GPP) Module fills 2 slots. Install as follows:
- Install in slot 3, fills slots 1 and 3
- Install in slot 4, fills slots 2 and 4
- Install in slot 7, fills slots 5 and 7
- Install in slot 8, fills slots 6 and 8
Module fills 2 slots. Install as follows:
- Install in slot 1, fills slots 1 and 3
- Install in slot 2, fills slots 2 and 4
- Install in slot 5, fills slots 5 and 7
- Install in slot 6, fills slots 6 and 8
- install in slot 11, fills slots 11 and 13
- install in slot 12, fills slots 12 and 14
- install in slot 15, fills slots 15 and 17
- install in slot 16, fills slots 16 and 18
CAUTION
If you do not install a module in a slot, you must leave the slot panel installed in the slot. If you
operate the chassis with an uncovered empty slot, the system will overheat.
Before installing a module in the chassis, have the following on hand:
• A # Phillips-head or flathead screwdriver.
• An ESD wrist strap with a plug for connection to the ESD connector on the chassis.
DANGER
For safety reasons, the ESD wrist strap should contain a series 1 megohm resistor.
To install a module in the chassis, complete the following tasks.
NOTE
You can install management modules in the FSX 800 and FSX 1600 chassis while it is powered on and
running.
1. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector
located on the chassis front panel.
2. Remove the module from the packaging.
3. Insert the management module or interface module into the appropriate slot and slide the card
along the card guide until the ejector levers rotate towards the module front panel.
NOTE
If you are installing SX-FI48GPP POE+ interface modules, refer to the table above for the slot
numbers where these modules may be installed. Each module occupies the equivalent of two slots,
so plan your installation accordingly. See the fifth and sixth figure below.
4. Fold the ejectors towards the center of the module to fully seat the module in the backplane.
5. Use the #2 Phillips-head or flathead screwdriver to tighten the screws on each side of the module
faceplate.
Installing FastIron SX Devices
Brocade FastIron SX Series Chassis Hardware Installation Guide 61
53-1003092-01