Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 150)

1 Fan Assembly
FIGURE 54 Removing a fan assembly from the FSX 1600 chassis.
4. Insert the new fan assembly into the fan slot and push the enclosure in until the face plate is flush
with the chassis. Pushing the enclosure in seats the fan connector with the chassis connector.
5. Secure the fan to the chassis by tightening the four captive screws.
6. Access the CLI, and enter the show chassis command to verify that both fans are operating
normally.
Replacing the air filter in the FastIron SX-1600
NOTE
It is recommended that Brocade switches and routers be installed in environments that have minimal
dust and airborne contaminants. If Brocade switches and routers are placed in operation in
environments where dust or other airborne contaminants may be prevalent, air filters should be
inspected annually and replaced if needed. Maintaining clean air filters ensures optimal airflow through
the device.
Replacing the air filter in the FastIron SX-1600
148 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01