Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 70)

DANGER
If the installation requires a different power cord than the one supplied with the device, make
sure you use a power cord displaying the mark of the safety agency that defines the
regulations for power cords in your country. The mark is your assurance that the power cord
can be used safely with the device.
NOTE
If the wall outlet is not rated 115 or 120V and 20A, stop and get the appropriate cable for the outlet.
Make sure you obtain a power cord displaying the mark of the safety agency that defines the
regulations for power cords in your country. The mark is your assurance that the power cord can be
used safely with the device.
NOTE
The wall outlet should be installed near the equipment and should be easily accessible.
NOTE
The FastIron X Series switch is designed to provide uninterrupted service even when you insert or
remove the interface modules. Therefore, the system does not have a separate on or off power switch.
To turn the system off, simply unplug the power cords.
DANGER
High Touch Current. Earth connection essential before connecting supply.
Connecting AC power to the chassis
AC power is supplied though an AC power cord that is connected to the back of the chassis. Perform
the following tasks to connect AC power to the chassis.
1. At the rear of the chassis, locate the power receptacles on the power supplies.
2. Lift the cord-retainer and connect a Brocade-supplied AC power cord to the power supply.
3. Snap the cord-retainer over the power plug to hold it in place.
Connecting AC power to the chassis
68 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01