Leds for 24-port copper module with poe – Brocade FastIron SX Series Chassis Hardware Installation Guide User Manual
Page 36
•
24 10/100/1000 copper ports
•
24 LEDs for port status
•
24 LEDs for PoE status
LEDs for 24-port copper module with PoE+
The front panel of the 24-port Gigabit Ethernet copper module includes 24 LEDs (top) that indicate the
status of each port, and 24 LEDs (bottom) that indicate the PoE status.
The copper ports provide status information using the LEDs described in the table below.
LEDs for 10/100/1000 copper ports
TABLE 10
LED
Position
State
Meaning
Link or Activity
Square LED located at upper left corner of to
port (for top port)
Square LED located at upper right corner of top
port (for bottom port)
On (Green) A link is established with the
remote port.
Blinking
The port is transmitting and
receiving traffic.
Off
No link exists with the
remote port.
PoE or PoE+(if
applicable)
Round LED located beneath the ports. The first
(left-most) LED is for port 1, the second LED is
for port 2, the third LED is for port 3, etc.
On (Green) The port is enabled, a
power-consuming device
has been detected, and the
module is supplying power
to the device.
Off
The port is not providing in-
line power.
Hardware features
34
Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01