Brocade FastIron SX Series Chassis Hardware Installation Guide User Manual
Page 144
Advertising
1.
Crimp #6 AWG ground wire and connect it to the ground position on the chassis. The ground
position is located on the side or rear of the chassis next to the ground symbol. Refer to the
illustrations in step 4 .
2.
Use a flathead screwdriver to remove the two screws holding the transparent cover over the
power supply lugs. The following illustration shows the location of the screws and lugs.
1
Screws holding power lugs
2
Screws holding transparent cover
3.
Use a Phillips-head screwdriver to remove each of the power lugs.
4.
Crimp #8 AWG input wire into the power lugs and reconnect the power lugs to the power supply
unit
1
#8 AWG power supply wire
Maintaining the Hardware
142
Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01
Advertising