Brocade FastIron SX Series Chassis Hardware Installation Guide - Manual (Page 74)

1 Screws holding power lugs
2 Screws holding transparent cover
FIGURE 33 Power lugs and cover screws
3. Use a Phillips-head screwdriver to remove the power lugs. Refer to the second figure below.
4. Crimp #8 AWG input wire into the power lugs and reconnect the lugs to the power supply unit.
Refer to the two figures below.
1 #8 AWG power supply wire
FIGURE 34 Power supply wire
Installing FastIron SX Devices
72 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1003092-01