Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 207)

Brocade Mobility 5181 Access Point Product Reference Guide 193
53-1002516-01
Viewing client statistics summary
7
5. Refer to the Traffic field to view individual Client RF throughput information.
6. Refer to the RF Status field to view Client signal and signal disturbance information.
7. Refer to the Errors field to view Client retry information and statistics on packets not
transmitted.
Packets per second The Total column displays average total packets per second
crossing the Client. The Rx column displays the average total
packets per second received on the Client. The Tx column displays
the average total packets per second sent on the Client. The
number in black represents Pkts per second for the last 30
seconds and the number in blue represents Pkts per second for
the last hour.
Throughput The Total column displays the average total packets per second
crossing the selected Client. The Rx column displays the average
total packets per second received on the Client. The Tx column
displays the average total packets per second sent on the Client.
The number in black represents throughput for the last 30
seconds, the number in blue represents throughput for the last
hour.
Avg. Bit Speed The Total column displays the average bit speed in Mbps for a
given time period on the Client. This includes all packets sent and
received. The number in black represents average bit speed for
the last 30 seconds and the number in blue represents average
bit speed for the last hour. Consider increasing the data rate of the
AP if the current bit speed does not meet network requirements.
For more information, see
“Configuring the 802.11a or 802.11b/g
radio” on page 121. The associated Client must also be set to the
higher rate to interoperate with the Mobility 5181 Access
Point
at that data rate.
% of Non-unicast pkts Displays the percentage of the total packets for the selected
mobile unit that are non-unicast. Non-unicast packets include
broadcast and multicast packets. The number in black represents
packets for the last 30 seconds and the number in blue
represents packets for the last hour.
Avg Client Signal Displays RF signal strength in dBm for the target Client. The
number in black represents signal information for the last 30
seconds and the number in blue represents signal information for
the last hour.
Avg Client Noise Displays RF noise for the target Client. The number in black
represents noise for the last 30 seconds, the number in blue
represents noise for the last hour.
Avg Client SNR Displays the Signal to Noise Ratio (SNR) for the target Client. The
Signal to Noise Ratio is an indication of overall RF performance on
your wireless network.