Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 235)

Brocade Mobility 5181 Access Point Product Reference Guide 221
53-1002516-01
Network Commands
8
Network WAN Commands
BR5181>admin(network.wan)>
Description
Displays the WAN submenu. The items available under this command are shown below.
For an overview of the WAN configuration options using the applet (GUI), see “Configuring WAN
settings” on page 101.
BR5181>admin(network.wan)> show
Description
Displays the Mobility 5181 Access Point WAN port parameters.
Syntax
Example
admin(network.wan)>show
Status : enable
WAN DHCP Client Mode : enable
IP Address : 157.235.112.32
Network Mask : 0.0.0.0
Default Gateway : 0.0.0.0
Primary DNS Server : 0.0.0.0
Secondary DNS Server : 0.0.0.0
Auto-negotiation : disable
show Displays the Mobility 5181 Access Point WAN configuration and the Mobility 5181 Access Point’s current
PPPoE configuration.
set Defines the Mobility 5181 Access Point’s WAN and PPPoE configuration.
nat Displays the NAT submenu, wherein Network Address Translations (NAT) can be defined.
vpn Goes to the VPN submenu, where the Mobility 5181 Access Point VPN tunnel configuration can be set.
conte
nt Goes to the outbound content filtering menu.
dynd
ns Displays the Dynamic DNS submenu, wherein dyndns settings can be defined.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the current configuration to the Mobility 5181 Access Point system flash.
quit Quits the CLI and exits the current session.
show Shows the general IP parameters for the WAN port along with settings for the WAN interface..