Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 422)

408 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
Configuring an IPSEC tunnel and VPN FAQs
B
5. Enter the WAN port IP address of AP #1 for the Local WAN IP.
6. Within the Remote Subnet and Remote Subnet Mask fields, enter the LAN IP subnet and mask
of AP #2 /Device #2.
7. Enter the WAN port IP address of AP #2/ Device #2 for a Remote Gateway.
8. Click Apply to save the changes.
NOTE
For this example, Auto IKE Key Exchange is used. Any key exchange can be used, depending on
the security needed, as long as both devices on each end of the tunnel are configured exactly
the same.
9. Select the Auto (IKE) Key Exchange radio button.
10. Select the Auto Key Settings button.