Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 211)

Brocade Mobility 5181 Access Point Product Reference Guide 197
53-1002516-01
Viewing known access point statistics
7
CAUTION
When using the Send Cfg to APs function to migrate an access point’s configuration to other
access points, it is important to keep in mind mesh network configuration parameters do not get
completely sent to other access points. The Send Cfg to APs function will not send the
“auto-select” and “preferred list” settings. Additionally, LAN1 and LAN2 IP mode settings will only
be sent if the sender’s AP mode is DHCP or BOOTP. The WAN’s IP mode will only be sent if the
sender’s IP mode is DHCP.
6. Click the Start Flash button to flash the LEDs of other Mobility 5181 Access Points detected
and displayed within the Known AP Statistics screen.
Use the Start Flash button to determine the location of the devices displayed within the Known
AP Statistics screen. When an Mobility 5181 Access Point is highlighted and the Start Flash
button is selected, the LEDs on the selected Mobility 5181 Access Point flash. When the Stop
Flash button is selected, the LEDs on the selected Mobility 5181 Access Point go back to
normal operation.
7. Click the Logout button to securely exit the Access Point applet. A prompt displays confirming
the logout before the applet is closed.