Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 236)

222 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
Network Commands
8
Speed : 100M
Duplex : full
WAN IP 2 : disable
WAN IP 3 : disable
WAN IP 4 : disable
WAN IP 5 : disable
WAN IP 6 : disable
WAN IP 7 : disable
WAN IP 8 : disable
PPPoE Mode : enable
PPPoE User Name : JohnDoe
PPPoE Password : *******
PPPoE keepalive mode : enable
PPPoE Idle Time : 600
PPPoE Authentication Type : chap
PPPoE State
admin(network.wan)>
For an overview of the WAN configuration options available using the applet (GUI), see
“Configuring WAN settings” on page 101.
BR5181>admin(network.wan)> set
Description
Defines the configuration of the Mobility 5181 Access Point WAN port.
Syntax
set wan enable/disable Enables or disables the Mobility 5181 Access Point WAN port.
dhcp enable/disable Enables or disables WAN DHCP Client mode.
ipadr <idx> <a.b.c.d> Sets up to 8 (using <indx> from 1 to 8) IP addresses <a.b.c.d> for the
Mobility 5181 Access Point WAN interface.
mask <a.b.c.d> Sets the subnet mask for the Mobility 5181 Access Point WAN interface.
dgw <a.b.c.d> Sets the default gateway IP address to <a.b.c.d>.
dns <idx> <a.b.c.d> Sets the IP address of one or two DNS servers, where <indx> indicates
either the primary (1) or secondary (2) server, and <a.b.c.d> is the IP
address of the server.
auto-
nego
tiatio
n enable/disable Enables or disables auto-negotiation for the access point WAN port.
spee
d <mbps> Defines the access point WAN port speed as either 10 Mbps or 100
Mbps.
dupl
ex <mode> Defines the access point WAN port duplex as either half or full.