Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 328)

314 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
System Commands
8
System SNMP Traps Commands
BR5181>admin(system.snmp.traps)
Description
Displays the SNMP traps submenu. The items available under this command are shown below.
BR5181>admin(system.snmp.traps)> show
Description
Shows SNMP trap parameters.
Syntax
Example
admin(system.snmp.traps)>show trap
SNMP Client Traps
Client associated : enable
Client unassociated : disable
Client denied association : disable
Client denied authentication : disable
SNMP Traps
snmp authentication failure : disable
snmp acl violation : disable
SNMP Network Traps
physical port status change : enable
denial of service : enable
denial of service trap rate limit : 10 seconds
SNMP System Traps
show Shows SNMP trap parameters.
set Sets SNMP trap parameters.
add Adds SNMP trap entries.
delete Deletes SNMP trap entries.
list Lists SNMP trap entries.
.. Goes to the parent menu.
/ Goes to the root menu.
save Saves the configuration to system flash.
quit Quits the CLI.
show trap Shows SNMP trap parameter settings.
rate-trap Shows SNMP rate-trap parameter settings.