Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 220)

206 Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
Network Commands
8
** LAN1 Information **
LAN Name : LAN1
LAN Interface : enable
802.11q Trunking : disable
LAN IP mode : DHCP client
IP Address : 192.168.0.1
Network Mask : 255.255.255.255
Default Gateway : 192.168.0.1
Domain Name :
Primary DNS Server : 192.168.0.1
Secondary DNS Server : 192.168.0.2
WINS Server : 192.168.0.254
** LAN2 Information **
LAN Name : LAN2
LAN Interface : disable
802.11q Trunking : disable
LAN IP mode : DHCP server
IP Address : 192.168.1.1
Network Mask : 255.255.255.255
Default Gateway : 192.168.1.1
Domain Name :
Primary DNS Server : 192.168.0.2
Secondary DNS Server : 192.168.0.3
WINS Server : 192.168.0.255
admin(network.lan)>
For information on displaying LAN information using the applet (GUI), see “Configuring the LAN
interface” on page 93.
BR5181>admin(network.lan)> set
Description
Sets the LAN parameters for the LAN port.
Syntax
set lan <mode> Enables or disables the Mobility 5181 Access Point LAN interface.
name <idx-name > Defines the LAN name by index.
ethernet-port-lan <idx> Defines which LAN (LAN1 or LAN2) is active on the Ethernet port.
timeout <seconds> Sets the interval (in seconds) the Mobility 5181 Access Point uses to
terminate its LAN interface if no activity is detected for the specified
interval.
trunking <mode> Enables or disables 802.11q Trunking over the Mobility 5181 Access
Point LAN port.
auto-negotiation <mode> Enables or disables auto-negotiation for the access point LAN port.
speed <mbps> Defines the access point LAN port speed as either 10 Mbps or 100
Mbps.