Br5181>admin(system.snmp.traps)> add – Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) User Manual
Page 330
316
Brocade Mobility 5181 Access Point Product Reference Guide
53-1002516-01
System Commands
8
For information on configuring SNMP traps using the applet (GUI), see
BR5181>admin(system.snmp.traps)> add
Description
Adds SNMP trap entries.
Syntax
Example
admin(system.snmp.traps)>add v1v2 203.223.24.2 333 mycomm v1
admin(system.snmp.traps)>list v1v2c
----------------------------------------------------------------------
index
dest ip
dest port
community
version
----------------------------------------------------------------------
1
203.223.24.2
333
mycomm
v1
admin(system.snmp.traps)>add v3 201.232.24.33 555 BigBoss none md5
admin(system.snmp.traps)>list v3 all
hotspot-Client-status
enable/disable
Enables/disables the hotspot Client
status trap.
vlan
enable/disable
Enables/disables VLAN traps.
lan-monitor
enable/disable
Enables/disables LAN monitor traps.
rate
<rate>
<scope>
<value>
Sets the particular <rate> to monitor to
<value> given the indicated <scope>.
See table below for information on the
possible values for <rate>, <scope>,
and <value>.
min-pkt
<pkt>
Sets the minimum number of packets
required for rate traps to fire
(1-65535).
add v1v2
<ip>
<port>
<comm>
<ver>
Adds an entry to the SNMP v1/v2 access list with the destination IP address set to <ip>, the
destination UDP port set to <port>, the community string set to <comm> (1 to 31 characters), and
the SNMP version set to <ver>.
v3
<ip>
<port>
<user>
<sec>
<auth>
<pass1>
<priv>
<pass2>
Adds an entry to the SNMP v3 access list with the destination IP address set to <ip>, the destination
UDP port set to <port>, the username set to <user> (1 to 31 characters), and the authentication type
set to one of none, auth, or auth/priv.
The following parameters must be specified if <sec> is not none:
Authentication type <auth> set to md5 or sha1
Authentication password <pass1> (8 to 31 chars)
The following parameters must be specified if <sec> is set to auth/priv:
Privacy algorithm set to des or aes
Privacy password <pass2> (8 to 31 chars)