Brocade Mobility 5181 Access Point Product Reference Guide (Supporting software release 4.4.0.0) - Manual (Page 363)

Brocade Mobility 5181 Access Point Product Reference Guide 349
53-1002516-01
System Commands
8
admin(system.fw-update)>set user mudskipper
admin(system.fw-update)>set passwd muddy
For information on updating access point device firmware using the applet (GUI), see “Updating
device firmware” on page 86.
BR5181>admin(system.fw-update)>update
Description
Executes the Mobility 5181 Access Point firmware update over the WAN or LAN port using either ftp
or tftp.
Syntax
NOTE
The access point must complete the reboot process to successfully update the device firmware,
regardless of whether the reboot is conducted uing the GUI or CLI interfaces.
admin(system.fw-update)>update ftp
For information on updating access point device firmware using the applet (GUI), see “Updating
device firmware” on page 86.
update <mode> Defines the ftp ot tftp mode used to conduct the firmware update. Specifies whether the
update is executed over the Mobility 5181 Access Point’s WAN, LAN1 or LAN2 interface
<iface>.